NC machine tool - position feedback package - Manufacturing Processes - 2

Q.  In NC (Numerical Control) machine tool, the position feedback package is connected between
- Published on 04 Aug 15

a. control unit and programmer
b. programmer and machine tool
c. control unit and machine tool
d. programmer and process planning

ANSWER: control unit and machine tool

Related Content

 

    Discussion

  • Royce Falleni   -Posted on 28 Oct 22
    Hi!
  • Pankaj Chaugule   -Posted on 19 Nov 15
    - In NC machine tool, the position feedback package is connected between control unit and machine tool.

    - The position command signals sent by tape to slideway transmission elements of machine are compared simultaneously the actual position achieved, with the help of position feedback signal.

    - The below diagram shows the Basic-Flow-Chart-of-Numerical-Controlled-Machine-Tool


➨ Post your comment / Share knowledge


Enter the code shown above:

(Note: If you cannot read the numbers in the above image, reload the page to generate a new one.)
▲