Boring operation - Correct hole location, size or alignment of hole - Manufacturing Processes - 2

Q.  Which operation can correct hole location, size or alignment of the hole which is already drilled in workpiece?
- Published on 04 Aug 15

a. Boring
b. Rimming
c. Both a. and b
d. None of the above

ANSWER: Boring

Related Content

 

    Discussion

  • Pankaj   -Posted on 05 Nov 15
    - Boring operation can correct hole location, size or alignment of the hole which is already drilled in workpiece.

    - It cab produce a good finish if a fine feed and a correct tools are used.

    - Whereas in rimming operation, the reamer tool follows the hole already in the workpiece and it cannot correct the hole location, size or alignment.

    - Even though the rimming is faster than boring, boring is often preferred over rimming, because of the advantage of hole correction.

➨ Post your comment / Share knowledge


Enter the code shown above:

(Note: If you cannot read the numbers in the above image, reload the page to generate a new one.)
▲