Compare mode operation - RC2/CCP1 configuration during CCP initialization

Q.  How does the pin RC2/CCP1 get configured while initializing the CCP module in the compare mode of operation?
- Published on 16 Nov 15

a. As an input by writing it in TRISC register
b. As an output by writing it in TRISC register
c. As an input without the necessity of writing or specifying it in TRISC register
d. Compare mode does not support pin RC2/CCP1 configuration CCP initialization

ANSWER: As an output by writing it in TRISC register

Post your comment / Share knowledge


Enter the code shown above:
 
(Note: If you cannot read the numbers in the above image, reload the page to generate a new one.)