Schmitt trigger circuit in PWM signal reception

Q.  In PWM signal reception, the Schmitt trigger circuit is used
- Published on 16 Oct 15

a. To remove noise
b. To produce ramp signal
c. For synchronization
d. None of the above

ANSWER: To remove noise
 
In pulse width modulation, the width of the carrier varies with the amplitude of the modulating signal at the time of sampling. In PWM signal reception, the received PWM signal is applied to the Schmitt trigger circuit. The Schmitt trigger circuit is used to remove noise in the PWM waveform. This output is the supplied further for detection of the original information.

Post your comment / Share knowledge


Enter the code shown above:
 
(Note: If you cannot read the numbers in the above image, reload the page to generate a new one.)