What is Newall system? - Metrology & Quality Control

Q.  Newall system is a type of
- Published on 07 Aug 15

a. bilateral hole based system
b. limit system
c. both a. and b.
d. none of the above

ANSWER: both a. and b.
 

    Discussion

  • Sravanthi   -Posted on 26 Oct 15
    Newall system is used to standardize limits and fits. This system provides range of clearance, transition and interference fits for sizes upto 12''.

    - It is a bilateral hole basis system with 6 grades of shaft tolerance and provides two classes of holes for different degree of precision.

    - The Newall system consists of two grades of bilateral holes, two of press fit, three clearance fits and one transition fit.

    - Newall system is also a limit system and the limits are given to six classes of shafts. These include F and D for press fit, P for transition fit, XYZ for clearance fit, where F = Force, D = Driving, P = Push, Z = Running, Y = Running, X = Running.

Post your comment / Share knowledge


Enter the code shown above:
 
(Note: If you cannot read the numbers in the above image, reload the page to generate a new one.)